Turn the T-bar
handle of the puller tool up until the tip clears the handle.
Place the arms under the faucet handle and hold the grip bar
firmly while turning the threaded system down into the screw
hole until the faucet handle is free.
Turn off the water
and remove the angle stop.
Insert the sleeve
puller into the copper tubing.
Insert the peg of
the faucet puller into the hole and place the puller jaws behind
the compression nut.
Turn the puller
handle and remove the nut and sleeve just like you would pull a
faucet handle. Some tapping of the puller may be necessary to
completely remove the sleeve and nut.